Client Copy executed on command line sets Client status to originating Status instead of STOP
Article ID: 84848
Updated On:
Products
CA Automic Workload Automation - Automation Engine
Issue/Introduction
Error Message :
N/A
When executing Client Copy from the command line, the utility sets Clients to "STOP" automatically, regardless of the Status of the Client being copied. The Status should be sourced from the original Client and applied to the new client, which means it could either be GO or STOP, depending on originating Client Status.
In AE version 10, clients copied via the command line were not set to GO automatically.
In AE version 11.2, they keep the original status of the copied client.
N/A
When executing Client Copy from the command line, the utility sets Clients to "STOP" automatically, regardless of the Status of the Client being copied. The Status should be sourced from the original Client and applied to the new client, which means it could either be GO or STOP, depending on originating Client Status.
In AE version 10, clients copied via the command line were not set to GO automatically.
In AE version 11.2, they keep the original status of the copied client.
Environment
Release: AUTWAB99000-11.0-Automic Workload Automation-Base Edition
Component:
Component:
Cause
Cause type:
Defect
Root Cause: Function in the UpdateCliendSpecData() in the Utility did not always check the return value.
Defect
Root Cause: Function in the UpdateCliendSpecData() in the Utility did not always check the return value.
Resolution
Update to a fix version listed below or a newer version if available.
Fix Status: Released
Fix Version(s):
Component(s): Utility
Automation Engine 12.0.1 – Available
Automation Engine 11.2.3 – Available
Automation Engine 11.1.5 – Available
Fix Status: Released
Fix Version(s):
Component(s): Utility
Automation Engine 12.0.1 – Available
Automation Engine 11.2.3 – Available
Automation Engine 11.1.5 – Available
Additional Information
Workaround :
N/A
N/A
Feedback
Yes
No
Powered by
