File Transfers using 'include sub directories' from Windows to Unix show wrong slash in path.
search cancel

File Transfers using 'include sub directories' from Windows to Unix show wrong slash in path.

book

Article ID: 84785

calendar_today

Updated On:

Products

CA Automic Workload Automation - Automation Engine

Issue/Introduction

Error Message :
N/A

File Transfers from Windows to Unix, with 'include sub directories' is checked, show report paths with backslash instead of slashes.

The problem occurs in exactly this constellation:

    Sender-Agent: Windows-Agent
    Receiver-Agent: Unix-Agent:
    Reverse connection, i.e., sender agent cannot connect to receiver agent

 

Environment

OS: Windows

Cause

Cause type:
Defect
Root Cause: The bug was found in the Windows-Agent:
*in reverse connection, the Windows agent by mistake tells the UNIX-Agent that he also is an UNIX-Agent
*however, the destination agent is a real UNIX agent and therefore does not turn the paths from Windows-paths to UNIX-paths, because it assumes the paths to be correct UNIX paths.

Resolution

Update to a fix version listed below or a newer version if available.

 

Fix Status: Released

Fix Version(s):
Component(s): Windows Agent

Automation Engine 11.2.3 - Available
Automation Engine 11.1.5 - Available
Automation Engine 10.0.8 - Available

Additional Information

Workaround :
N/A