Number of PRINT lines in-between BEGINREAD/ENDREAD is limited when running jobs on Java UI
Article ID: 84443
Updated On:
Products
CA Automic Workload Automation - Automation Engine
AUTOMIC WORKLOAD AUTOMATION
Issue/Introduction
Error Message :
U04006752 Cannot display dialog 'test'. The maximum number of 510 input rows was exceeded.
This issue happens to script command BEGINREAD / ENDREAD on Java UI.
If more than 510 lines are put between BEGINREAD and ENDREAD, the below error message appears when it runs on the Java UI:
The same script runs fine from the Automic Web Interface (AWI) or the Enterprise Control Center (ECC).
This issue is found on Java UI v11.2.x.
But is not seen in AWI / ECC on same the version or on v12.
U04006752 Cannot display dialog 'test'. The maximum number of 510 input rows was exceeded.
This issue happens to script command BEGINREAD / ENDREAD on Java UI.
If more than 510 lines are put between BEGINREAD and ENDREAD, the below error message appears when it runs on the Java UI:
U04006752 Cannot display dialog 'test'. The maximum number of 510 input rows was exceeded.
The same script runs fine from the Automic Web Interface (AWI) or the Enterprise Control Center (ECC).
This issue is found on Java UI v11.2.x.
But is not seen in AWI / ECC on same the version or on v12.
Cause
Cause type:
By design
Root Cause: Limiatation of the Java User Interface.
By design
Root Cause: Limiatation of the Java User Interface.
Environment
OS Version: N/A
Resolution
Use the Automic Web Interface (AWI) or the Enterprise Control Center (ECC).
Fix Status: No Fix
Fix Version(s):
N/A
Fix Status: No Fix
Fix Version(s):
N/A
Additional Information
Workaround :
N/A
N/A
Feedback
Yes
No
Powered by
