ALERT: Some images may not load properly within the Knowledge Base Article. If you see a broken image, please right-click and select 'Open image in a new tab'. We apologize for this inconvenience.
Missing information or incorrect picture in Proxy documentation
Article ID: 84387
Updated On:
Products
CA Automic Workload Automation - Automation Engine
Issue/Introduction
Error Message :
N/A
When navigating to the following page in the Proxy 2.0 Guide:
Scroll down to the section "Active Load Balancing".
The text states that Client Proxy 1 (PC1) forwards connections from Agents 1 and 2 from Server Proxy 1 (PS1) to CP1 and CP3, but only CP001 is shown as connected (with two arrows). The same is shown for PC2 - only the CP002 connection is shown. These should show connections to CPs 3 and 4, respectively.
N/A
When navigating to the following page in the Proxy 2.0 Guide:
Scroll down to the section "Active Load Balancing".
The text states that Client Proxy 1 (PC1) forwards connections from Agents 1 and 2 from Server Proxy 1 (PS1) to CP1 and CP3, but only CP001 is shown as connected (with two arrows). The same is shown for PC2 - only the CP002 connection is shown. These should show connections to CPs 3 and 4, respectively.
Cause
Cause type:
Other
Root Cause: Incorrect diagram in documentation.
Other
Root Cause: Incorrect diagram in documentation.
Environment
Release: WAASER99000-1.0-Automic Workload Automation-Services
Component:
Component:
Resolution
Update to a fix version listed below or a newer version if available. where the screenshot has been corrected in the AWA documentation for v12.2 and v12.0.
Fix Status: Released
Fix Version(s):
Documentation has been updated online to reflect the correct information.
Automation Engine 12.0 Online - Released
Fix Status: Released
Fix Version(s):
Documentation has been updated online to reflect the correct information.
Automation Engine 12.0 Online - Released
Additional Information
Workaround :
N/A
N/A
Feedback
Yes
No
Powered by
