ALERT: Some images may not load properly within the Knowledge Base Article. If you see a broken image, please right-click and select 'Open image in a new tab'. We apologize for this inconvenience.
Problem Upgrading TDM Portal 4.3 from 4.2.10
Article ID: 8432
Updated On:
Products
CA Test Data Manager (Data Finder / Grid Tools)
Issue/Introduction
After upgrading from the 4.2 version to the 4.3 version that just went GA September 29, 2017, TDM GT Datamaker shows the correct version, but the TDM Web Portal still shows 4.2. Why is this?
Steps that were done prior to installing the TDM Web Portal:
- Removed it (i.e. uninstalled from the control panel).
- Deleted all the folders it created.
- Verified that the Registry did not contain any entries for the TDM Web Portal.
- Rebooted the machine after clean up.
- Installed TDM Web Portal from scratch.
- Did this same series of steps when migrating from 4.1 to 4.2, but the clean-up process worked in that upgrade.
- Failed in this upgrade.
Environment
TDM 4.2 to 4.3
Resolution
Based on the series of steps performed and the fact that it only fails to list the Version in the TDM Web Portal, the last clean up item left to do is clear the browser cache. It should be noted that the Chrome browser immediately started showing the correct version while the IE browser to up to 5x's to finally clear the cache. However, after clearing the cache, both browsers should show the 4.3 version.
Feedback
Yes
No
Powered by
