PSP not showing up in MWF Select list

Products

• MICS Resource Management

Issue/Introduction

After running the initial job to install a MICS PTF, the PSP does not show up in in the 'Select Product Changes' panel in MWF 5;2;1;2.

The PSPADD member; however, in 'sharedprefix.PSP.CNTL' does show that the new PTF has been registered.  

Cause

The 'sharedprefix.PSP.PC.TEXT' dataset was missing the @@ccc member (where ccc is the component ID).   This is likely from not selecting that particular component on the previous PAX ESD install.   

 

Resolution

For example, if this is a DB2 PTF that is not showing up, check that the @@DB2 member exists in 'sharedprefix.PSP.PC.TEXT'.  If it does not, then create this member and add only one line that contains the following

00010000

After creating this new member, then run the receive PSP tables again from MWF 5;2;4;1.

Then access the 'Select Product Changes' panel again where the PSP should now display