Workaround for a PMA Customization Error starting in Step 7
search cancel

Workaround for a PMA Customization Error starting in Step 7

book

Article ID: 8206

calendar_today

Updated On:

Products

Mainframe Application Tuner

Issue/Introduction

Submitted Step 7 of the PMA customization, job completed successful but I received the below error upon exiting the JCL screen:

10.40.31 JOB23375 $HASP165 SZVFPF01 ENDED AT GMTST01 MAXCC=0000 CN(INTERNAL) 

IKJ56500I COMMAND CUSTATCC NOT FOUND 

84 *-* CUSTATCC CUSTJT07 

+++ RC(-3) +++ 

*** ERROR OCCURED IN PMA CUSTOMIZATION *** 

PROCEDURE: SYSI.CA.MATUNER.V12R0AA.CEETSAMP(CUSTAT07) 

LINE# : 84 

RC : -3 

*** PMA CUSTOMIZATION ABNORMAL TERMINATED *** 

***

 

Environment

Release:
Component: MATUNE

Resolution

Found a work around for it.

After each step completed successfully (batch job), I would get the error trying to go back to the main customization exec.

I would then update the member CUST$STP to the next step and go back in.  This allowed me to move forward through the remaining steps until everything was completed.