ALERT: Some images may not load properly within the Knowledge Base Article. If you see a broken image, please right-click and select 'Open image in a new tab'. We apologize for this inconvenience.
Flapping BAD LINK DETECTED alarm on interface model in Spectrum
Article ID: 7966
Updated On:
Products
CA Spectrum
Issue/Introduction
Every few seconds, Spectrum is asserting and then clearing the BAD LINK DETECTED alarm on an interface model
Environment
Release: Spectrum 10.2.1 and below
Component:
Resolution
This issue has been addressed in in Spectrum 10.02.02.00 and higher.
Reference:
Symptom: Interface model was asserting then clearing the BAD LINK DETECTED alarm every few seconds.
Resolution: Due to change in IPLS of connected device's port(DISABLED STATE) , this device's port has flapping bad link alarms .Resolved it by controlling the change in IPLS to 'link_status_good ' of second device when its link_condition is 'link_disabled'. .
(10.2.2, DE286542, 00712250)
Feedback
Yes
No
Powered by
