Unable to run Spectrum OneClick Quick Device Search using an IPv6 address

Products

• CA Spectrum

Issue/Introduction

User reported that he is not able to search device by IPv6 address in the OneClick Quick Device Search field on the top right comer of the OneClick console. When an IPv6 address is entered, the "Go" button is grayed out.

<Please see attached file for image>

Environment

Release: a7n0c000000PBNr
Component:

Resolution

This is functioning as designed. The following "Note" is seen in the "About OneClick Quick Device Search" section of the documentation:

"Note: Ensure to enter a valid IP address when you find by IP address. Only a valid IPv4 address enables the search." 

https://docops.ca.com/ca-spectrum/10-3-0/en/administrating/oneclick-administration/managing-searches#ManagingSearches-AboutOneClickQuickDeviceSearch

Additional Information

IPv6 support for the OneClick Quick Device Search is planned for a future release of Spectrum. No specific release set at the time this knowledge document was published.