ALERT: Some images may not load properly within the Knowledge Base Article. If you see a broken image, please right-click and select 'Open image in a new tab'. We apologize for this inconvenience.
Rebuilding a Secondary Hub after it has been overwritten
Article ID: 77673
Updated On:
Products
DX Unified Infrastructure Management (Nimsoft / UIM)
NIMSOFT PROBES
Issue/Introduction
I have accidentally completely overwritten a Secondary Hub. How can I get everything back up and running again?
Environment
UIM 8.x
Resolution
The overwritten hubs can be safely reinstalled. Restore any backup up hub.cfg or reconfigure it. All robots attached to the hub previously will reattach to the hub with the same IP and ports as soon as the robot/hub is listening again on the open ports.
Feedback
Yes
No
Powered by
