Not Able to See the Request (RE) Command in the xFlow Command Bar

book

Article ID: 76526

calendar_today

Updated On:

Products

SUPPORT AUTOMATION- SERVER CA Service Desk Manager - Unified Self Service KNOWLEDGE TOOLS CA Service Management - Asset Portfolio Management CA Service Management - Service Desk Manager

Issue/Introduction

Not Able to See the Request (RE) Command in the xFlow Command Bar

Cause

The ticket type (Incident or Request) allowed for creation via the xFlow Command Bar is controlled by a CA Service Desk Manager configuration.

A CA Service Desk Manager Administrator can set a default ticket type for the tickets created by analysts via the xFlow interface.

 

Environment

CA SDM 14.0.03 or later and 17.x
xFlow installed
All Supported Operating Systems

Resolution

Follow the below steps to set the default ticket type for the xFlow interface:


1.  Login to CA Service Desk Manager as an Administrator

2.  Navigate to Administration-> xFlow Analyst Interface->General.  From the General Configuration List, select TicketType.

3.  Click EDIT and enter one of the following values in the Configuration Value field:

  • 0: The ticket type is Incident.
  • 1: The ticket type is Request.
  • 2: The ticket types are Incident and Request. However, the default ticket type is Incident.
  • 3: The ticket types are Incident and Request. However, the default ticket type is Request.

4. Click SAVE to save the changes

After the changes have been made, the REQUEST (RE) command will be available via the xFlow Command Bar.

Additional Information

https://docops.ca.com/ca-service-management/17-1/en/using/xflow-analyst-interface/create-a-ticket-in-the-xflow-analyst-interface