CA Fast Unload S0C1 NO ACTIVE MODULE after upgrade
book
Article ID: 76449
calendar_today
Updated On:
Products
Database Analyzer for DB2 for z/OSFast Unload for DB2 for z/OSFast Check for DB2 for z/OSFast Index for DB2 for z/OSRapid Reorg for DB2 for z/OS
Issue/Introduction
Encountering a S0C1 abend NO ACTIVE MODULE / UNKNOWN when executing CA Fast Unload for DB2 for z/OS (PFU) following upgrade to a new release. Executing two different CA DB2 tools releases concurrently in the same environment.
Environment
Release: Component: PFU
Cause
The PFU JCL contained a //STEPLIB DD but did not allocate the current release hlq.CDBALOAD. The previous release hlq.CDBALOAD is in the LINKLIST.
Resolution
Once the current release hlq.CDBALOAD was allocated to the //STEPLIB DD this resolved the S0C1 abend.