When applying fixes to CA Symdump CICS r 9.1 the client receives message NO APPLICABLE ++VER for several PTFS.
Article ID: 7607
Updated On:
Products
Issue/Introduction
The client is applying outstanding maintenance for CA Symdump CICS r 9.1. The receive step for some of the PTFS fails with the following messages
RO80943 NOT RECEIVED PTF NO APPLICABLE ++VER NOT ASSIGNED CAP1505 SYSMOD NOT IN RECEIVE STATUS
RO81564 NOT RECEIVED PTF NO APPLICABLE ++VER NOT ASSIGNED CAP1506 SYSMOD NOT IN RECEIVE STATUS
RO81912 NOT RECEIVED PTF NO APPLICABLE ++VER NOT ASSIGNED CAP1506 SYSMOD NOT IN RECEIVE STATUS
Environment
Cause
The fixes that generated the message “NO APPLICABLE ++VER’ are for FMID (CCSA910). FMID (CCSA910) is the CA Intertest CICS r 9.1 debugging FMID. The CA Intertest for CICS FMID (CCSA910) is not required for an CA Symdump CICS only install.
Resolution
When you receive the message below on any receive step
PTF number RO##### NOT RECEIVED PTF NO APPLICABLE ++VER
You need to check if that FMID has been received in that SMP/E environment. If the FMID is not present in the SMP environment - CSI then that message is valid.
The following JCL can be used to list the FMID’S in the CSI.
JOBCARD
//LIST EXEC PGM=GIMSMP
// PARM='CSI=SYMDUM91.GA.CSM.CSI'
//SMPCNTL DD *
SET BDY(GLOBAL).
LIST GLOBALZONE.
/*
//
Feedback
