Remove unneeded parameters from display
Article ID: 74265
Updated On: 04-04-2018
Products
Top Secret
Top Secret - LDAP
Issue/Introduction
IMS
PWVIEW
Our auditors requested us to remove any recollection for obsolete/unneeded TOP SECRET Startup parameters .
hese include : RDT2BYTE, IMS and PWVIEW All three parameters are absent from TOP SECRET startup parameters .
However , when TSS MODI command is issued , RDT2BYTE is still marked as active , IMS shows some values (which are irrelevant to us because we don't have IMS) and
PWVIEW is displayed with NO .
understand that RDT2BYTE is set always to 2 bytes . Am I correct ?
Also does that mean that I can safely remove it from Startup Parameters ?
Is there a way to eliminate displaying these parameters ?
PWVIEW
Our auditors requested us to remove any recollection for obsolete/unneeded TOP SECRET Startup parameters .
hese include : RDT2BYTE, IMS and PWVIEW All three parameters are absent from TOP SECRET startup parameters .
However , when TSS MODI command is issued , RDT2BYTE is still marked as active , IMS shows some values (which are irrelevant to us because we don't have IMS) and
PWVIEW is displayed with NO .
understand that RDT2BYTE is set always to 2 bytes . Am I correct ?
Also does that mean that I can safely remove it from Startup Parameters ?
Is there a way to eliminate displaying these parameters ?
Environment
z/os
Resolution
There is currently no way, not to display these TSS control options.
Also it is correct that RDT2BYTE is always set to yes.
Also it is correct that RDT2BYTE is always set to yes.
Feedback
Was this article helpful?
Yes
No
Powered by
