What to do Upon Receiving a SARTIA09 Message, with Bad Primary or Duplex Tapes.
search cancel

What to do Upon Receiving a SARTIA09 Message, with Bad Primary or Duplex Tapes.

book

Article ID: 7320

calendar_today

Updated On:

Products

Deliver View

Issue/Introduction

What to do upon receiving a SARTIA09 message, with bad or no primary or duplex tapes.

 

Environment

CA View - All Releases

Resolution

If there bad or non-existent Primary or Duplex tapes, but a DR tape exists:

 . . Set SARINIT DRTAPE=ACTIVE.

 . . Run SARPAC, using TAPESEQ=nnnnn-nnnnn, of the tape sequence numbers of the bad Primary tapes, and the SARPAC job

     will use the corresponding DRTAPE as input to the job and will create a new Primary tape, Duplex tape, and a new DRTAPE

     as output.