IGD306I UNEXPECTED ERROR DURING IEFSJRTE PROCESSING FOR ACCEPT JOB

book

Article ID: 7039

calendar_today

Updated On:

Products

CA RC/Migrator CA Endevor SCM Interface DB2 Administration CA RC Compare for DB2 for z/OS CA RC Extract for DB2 for z/OS CA RC/Query CA RC Secure for DB2 for z/OS CA RC Update for DB2 for z/OS CA Database Analyzer for DB2 for z/OS CA Fast Unload for DB2 for z/OS CA Fast Check for DB2 for z/OS CA Fast Index for DB2 for z/OS CA Fast Load for DB2 for z/OS CA Rapid Reorg for DB2 for z/OS

Issue/Introduction

The ACCEPT Job failed with the following message:

IGD306I UNEXPECTED ERROR DURING IEFSJRTE PROCESSING  

           RETURN CODE 8 REASON CODE 11014

           THE MODULE THAT DETECTED THE ERROR IS IGDIDMSI

           SMS MODULE TRACE BACK - IDMSI IDMRS IDMCD IDM00 SSIRT

           SYMPTOM RECORD CREATED, PROBLEM ID IS IGD00009

 11.09.22 JOB05433  IKJ56893I DATA SET SYSP.CAHOJ00.F3 NOT ALLOCATED+

 

 

Environment

Release:
Component: GEN

Resolution

Changing Region=0M resolved this problem. Here is the explanation of IGD306I from QW: 

An unexpected error occurred during storage management subsystem processing. This message could also appear for the allocation of existing SMS 

-managed data sets, if one or more of the volumes to be allocated is pending offline. 

In the message text: 

errmodnm The module that was in control when this unexpected error occurred. 

rc The return code returned from the error module. 

rsnc The reason code returned from the error module. 

callernm The module that detected this error. 

mtb The sequence of calling modules, starting from the module that 

detected the problem. The sequence can contain up to 18 modules names. 

probid The problem ID for the symptom record that was recorded in the 

logrec data set. 

System Action: The system ends the request, and writes an error record with problem ID probid to the logrec data set. 

Application Programmer Response: Use the message text and the entry with problem ID probid in the logrec data set for information about the error 

that occurred. Depending on the ERRMODNM value, the return and reason code can be found in one of the following locations:  

o If ERRMODNM begins with or contains any of the following characters, see OS/390 DFSMSdfp Diagnosis Reference for the return and reason codes 

- IGD, indicating storage management subsystem (SMS)