The PANV629E message was outputted when PSINIT was executed.

Products

• Panvalet

Issue/Introduction

The PANV629E message was outputted as follows when we executed the PSINIT for Panvalet subsystem.

 $HASP373 PSINIT STARTED
 IEF403I PSINIT - STARTED - TIME=hh.mm.ss
 CAS9075I - SERVICE(CA-RIM/BASE ) VERS(1400) GENLVL(E100AS900)
 CAS9111I - VIOLATION MESSAGE DEFERMENT THRESHOLD LOCATED IN ESQA AT 02482C2C.
 CAS9115I - INPUT: PRODUCT(PANV) VERSION(X7E6) INIT(PSINIT) PARM(00,PANV,14.6A,
 PANV600I  PANVALET SUBSYSTEM INITIALIZATION IN-PROGRESS
 IEE252I MEMBER PANSYS00 FOUND IN SYS1.PARMLIB
 PANV629E  PSIN2146: REQUIRED MODULE NOT FOUND IN LPALIB: PSDFI146
 PANV617E  PANVALET SUBSYSTEM TERMINATING DUE TO ERROR
 PANV624I  PANVALET SUBSYSTEM TERMINATION COMPLETE
 CAS9130I - MODULE PSINIT   COMPLETE, RC=00
 IEF404I PSINIT - ENDED - TIME=hh.mm.ss
 $HASP395 PSINIT ENDED

Environment

z/OSPanvalet R14.6

Cause

The PSDFI146 module does not exist in the LPA area.

Resolution

1. Please check the existence of module by the following command.

 D PROG,LPA,MODNAME=PSDFI146

 You will receive the following message.

 RESPONSE=xxxx
  CSV550I hh.mm.ss LPA DISPLAY nnn
    PSDFI146 WAS NOT FOUND IN THE LPA

 

2. Please check the "SYS1.PARMLIB(LPALSTxx)" to confirm the LPA registration status.

    If the Prefix.CBA3LPA is not registered, please add it.

 

3. Please IPL your system by using the CLPA parameter.

Additional Information

The following is description of Messages Guide.

 

PANV629E 

   mmmmmmmm: REQUIRED MODULE NOT FOUND IN LPALIB: nnnnnnnn

   Reason:
   Program mmmmmmmm attempted to locate module nnnnnnnn in LPA and failed. The subsystem is not initialized.

   Action:
   Check your installation process for errors. If necessary, reinstall the subsystem correctly or make the indicated module available in LPA before attempting to restart the subsystem again.