DCIM - ports used by Ecometer
search cancel

DCIM - ports used by Ecometer

book

Article ID: 67851

calendar_today

Updated On:

Products

CA ecoMeter

Issue/Introduction

What Ports are used by default at CA Ecometer

Environment

Release:
Component: ECOMET

Resolution

SNMP:
Default: 161

UDP:
Specifies the User Datagram Protocol (UDP) port. Defaults to $port so that the port number is specified when a device instance is defined.

The standard BACnet port is 47808.

TCP/COM:
For Modbus TCP/IP connection, specifies the device TCP/IP port (the Modbus standard is port 502). For Modbus Serial RTU connection, specifies the COM port number on the device.


RF Code Zone Manager:
Specifies the port number used by Zone Manager.
Example: 6580

If the installation program exits with a message that the Windows SNMP trap service is running, the program cannot configure TrapEXPLODER because both Windows SNMP trap service and TrapEXPLODER use port 162.

You must either disable the Windows SNMP trap service or configure TrapEXPLODER to use a different port.

Web Server:
The default port is 80, but any available port can be specified.

The installation checks to see if the specified port is in use.


PostgreSQL database Server port
Default:5432


CA ecoMeter web port number
Accept the default port or enter the number of a different available port.
Default: 8090
This port number should be available. If not, use port number 8081.