USM just stays on loading window after upgrade to UIM 8.51


Article ID: 6484


Updated On:


DX Infrastructure Management NIMSOFT PROBES


After upgrading to 8.51. I log into UMP and USM just shows this screen and never gets past it. I do not get any error message.


<Please see attached file for image>



Alarm management has been moved to EMS in UIM 8.51.

To validate this issue is being caused by EMS, change the url for your ump to the following:


After the session section you will see these entries:

If EMS is the issue it will look like this:

<Please see attached file for image>


<Please see attached file for image>


This is a normal entry:

<Please see attached file for image>


Notice how the bad entry does not have the alarm messages above MyUsr.





Release: CNMSPP99000-8.51-Unified Infrastructure Mgmt-Server Pack-- On Prem


To resolve this issue.

rdp or ssh to the primary uim.

Launch Infrastructure manager (IM) or admin console.

  1. copy the ems folder to a backup location.
    On Windows the path is C:\Program Files (x86)\Nimsoft\probes\service
    On Linux the path is /opt/nimsoft/probes/service
  2. delete the ems probe from IM or admin console
  3. delete the ems folder from the OS
  4. deploy ems from the archive
  5. start ems
  6. log out of UMP and back in. There is no need to restart wasp.

If you had customization in EMS, you can copy the entries from the backed up ems folder. If USM stops working again when the customization is added, then  remove the customization, and call in a new case to support.



Additional Information

Article is valid as of May 3, 2017


1558714703638000006484_sktwi1f5rjvs16tji.png get_app
1558714701883000006484_sktwi1f5rjvs16tjh.png get_app
1558714699977000006484_sktwi1f5rjvs16tjg.png get_app
1558714697827000006484_sktwi1f5rjvs16tjf.png get_app