The Bind customization task, ssid0002, issues a warning message stating that SETUP00 includes a duplicate definition for the local subsystem.

Products

• RC Compare for DB2 for z/OS
• Database Analyzer for DB2 for z/OS
• Fast Unload for DB2 for z/OS
• Fast Check for DB2 for z/OS
• Fast Index for DB2 for z/OS
• Rapid Reorg for DB2 for z/OS

Issue/Introduction

When installing or upgrading the CA Database Management Solutions for DB2 for z/OS, the Bind Product Packages and Plans customization task, ssid0000, may issue warning message:

**** WARNING
**** Parmlib member SETUP00 includes remote location DDF_location_name/ssid.
**** This is a duplicate definition for local subsystem DDF_location_name 
**** and will be omitted from remote DRDA package binds.                  

 

 

Environment

Release:
Component: INS

Cause

In the SETUP definition for this subsystem, ssid, check the settings for the following two parameters in the subsystem definition for this ssid:

SSREMOTE

LOCATION

 

It is most likely that the SSREMOTE parameter is set to (YES) and that the LOCATION parameter is not set to (LOCAL).

Resolution

For the local subsystem definition, where you are executing the bind statements, I would normally expect to see the following:

SSID (ssid)
....
LOCATION (LOCAL)    <-- specify LOCAL not a location name               
LOCSSID (ssid)

If it is not your intention to generate remote bind statements then set SSREMOTE to (NO).

If however, your intention is to bind packages locally and remotely then specify SSREMOTE (YES). Please be aware though, that if you have several remote subsystems assigned to a given local subsystem, you may find that this job becomes too large, or one or more of the subsystems may not be active.

SSID (ssid)
....
LOCATION (LOCAL) 
LOCSSID (ssid)

LOCATION (DDF_location_name_1) 
LOCSSID (remote_ssid_1) 

LOCATION (DDF_location_name_2) 
LOCSSID (remote_ssid_2) 

If this occurs, change the SETUPxx member DRDA Remote Binds option (SSREMOTE) to NO for each subsystem and use bind task 0 to generate and execute the bind job separately on the local subsystem and then on each remote subsystem.  

Additional Information

Please refer to the following documentation for further details on the 

Bind Product Packages and Plans customization task

Further details on the SETUP Parmlib member can be referenced at

Create a SETUP Global Parmlib member