If Execution Mode is misspelled, deployed Virtual Services disappears from UI Portal

Article Id: 6262
Status: Published
Updated On: 14-02-2018 07:09
Legacy Id: TEC1422711
Products:
CA Application Test , Service Virtualization , CA Continuous Application Insight (PathFinder)
Issue/Introduction:

Steps to Reproduce:
*************************

(1)    Deploy some VS’ in VSE.

(2)    Go to Portal UI >> Monitor-> Virtual Service Environments -> VSE and you will see these VS’ listed as running.

<Please see attached file for image>

before.PNG

(3)    Add the property ‘lisa.vse.execution.mode’ (Without quotes) in project.config file and give its value as “EIFICIENT”.

(4)    Deploy (Not re-deploy) any other VS.

 

(5)    Once again go to Portal UI >> Monitor-> Virtual Service Environments -> VSE and you will see all the VS’ that were listed as running are not seen anymore. 

<Please see attached file for image>

after.PNG

Cause:

Known issue in the product - Defect DE276067

Environment:

DevTest 9.5.1

Resolution:

Please contact CA Support for a patch for this issue. Please refer to the defect ID DE276067 when you contact CA Support

Additional Information:

This issue is fixed in DevTest 10.1 release (Next GA release as on 18th Mar 2017) 

insert_drive_file 1558707907679000006262_sktwi1f5rjvs16qux.png
arrow_downward Download
insert_drive_file 1558707905847000006262_sktwi1f5rjvs16quw.png
arrow_downward Download