LMINIT for IDB2VARS failed with RC = 8 processing Sysview for Db2 within Post Install

Products

• SYSVIEW Performance Management Option for DB2 for z/OS

Issue/Introduction

Attempting to complete the Sysview Performance Management Option for Db2 for z/OS (IDB2) post installation and during the
Db2 task select section for IDB2 SYSVIEW for DB2:
IDB2 specific install tasks (ssid0550) user received the following message after attempting to create the ssid0550 job:

Please wait while the JCL is being generated for the Db2 Tasks. Note that you may be prompted for additional information needed to generate the tasks.    
Current Task...: SYSVIEW FOR DB2: DB2 SPECIFIC INSTALL TASKS   Output Data Set: 'hlq.CDBASAMP'        Output Member..: ssid0550                                            

THE INITIAL PART OF THE CA SYSVIEW FOR DB2 POST INSTALL    
"EXECUTE PRODUCT SPECIFIC CUSTOMIZATION TASKS" FROM THE DB2
TOOLS INSTALLATION MAIN MENU HAS NOT BEEN COMPLETED        
SUCCESSFULLY. ONE OR MORE OF THE FOLLOWING INSTALL DATASETS
ARE MISSING OR ARE NOT AT THE CORRECT LEVEL:               
INST LEVEL: '170'                                          
 CUR LEVEL: '180'                                        
  SOURCE: 'hlq.SOURCE' OK
  SECURITY: 'hlq.SECURITY' OK
 TGTREQ: 'hlq.CDBATREQ' OK          

YOU MUST PERFORM THE PRODUCT SPECIFIC CUSTOMIZATION TASK   
FOR CA SYSVIEW FOR DB2 BEFORE YOU CAN PERFORM THE "EXECUTE
DB2 TASKS" FOR CA SYSVIEW FOR DB2. REFER TO THE            
INSTALLATION GUIDE FOR MORE INFORMATION. 

Resolution

The incorrect DSNAMExx was the cause for this error. After going back and starting the post installation process over from scratch, site found that there
were multiple parmlib(s) setup with various members.  Tracked the correct DSNAMExx member and successfully built the jobs for the upgrade.
Pointing to the correct DSNAMExx member resolved the problem.