CA Datacom DL1 Transparency (DL1T) activated for use in a MUF?

Products

• Datacom

Issue/Introduction

I am not sure if CA Datacom DL1 Transparency (DL1T) has been activated for use in a CA Datacom Multi-user (MUF)? How can I tell?

Environment

Release: DATABB00200-12-Datacom/AD
Component:

Resolution

To tell if a CA Datacom Multi-user (MUF) was set up for the CA Datacom DL1 Transparency (DL1T) product:

Check to see if DBID 014 exists. DBID 014 is the "FATTAT" database that your site would have prepared with all the IMS definitions used by DL1T to convert DL1 calls to Datacom calls. 

One way to check is to run batch DBUTLTY with input REPORT AREA=CXX,DBID=014. 

If you have CA SYSVIEW, check via command DCDBASES.

If DBID 014 exists, then...

Check the MUF log for the DL1T component activation startup option:

DATACOM DL1T

If DL1T option is activated in the MUF startup…

Check to see if there was any use in this MUF session. Look for the open message for DBID 014 in the MUF log:

DB00903I - OPENED, BASE - 14