Sysview for Db2 Data Collector failure DBG99001E ERROR IN COMMAND STREAM
search cancel

Sysview for Db2 Data Collector failure DBG99001E ERROR IN COMMAND STREAM

book

Article ID: 57644

calendar_today

Updated On:

Products

SYSVIEW Performance Management Option for DB2 for z/OS

Issue/Introduction

Encountering the following messages when starting a Sysview for Db2 for z/OS (IDB2) Data Collector: 

DBG39049I 22:30:54 INITIALIZING CA SYSVIEW FOR DB2 nn.0
DBG99001E xxxx 22:30:54 ERROR IN COMMAND STREAM, PROCESSING ENDED OEVN003I OPSEVENT State: DOWN 
DBG39039I xxxx 22:30:54 TERMINATION COMPLETE FOR DATA COLLECTOR FOR DB2 SUBSYS 

Cause

The problem was caused by the use of non numerical value for the suffix.

Resolution

The problem was caused by the use of non numerical value for the suffix.

PARMLIB/XMAN/XNET Parameters 

The following parameters are used to locate connection plan names and XNET and XManager address spaces: 

ENV=nn 

Specifies the environmental suffix value that determines which parmlib members to use. The parmlib members control which plan names and Xmanager task to use. If SUFFIX is also coded, the ENV parameter is used instead. 

If you specify non numerical value, include the value in single quotation marks. For example, 'XX'. 

SUFFIX=nn 

Specifies the suffix value to use when reading parmlib members. The parmlib members control which plan names and Xmanager task to use. If ENV is also coded, the ENV parameter is used instead. 

Default: 00 

If you specify nonnumerical value, include the value in single quotation marks. For example, 'XX'.