Auto update/refresh of screen displays

Products

• SYSVIEW Performance Management
• NXBRIDGE - SYSVIEW/ENDEVOR

Issue/Introduction

Auto update/refresh of screen displays in SYSVIEW

 

Environment

Release:
Component: SYSVW

Resolution

You can use the UPDATE Command.

 

The UPDATE command specifies an automatic refresh interval for a display. It can also specify how long to stay in the automatic refresh mode as well as the command to be issued.

The UPDATE Interval cannot be less than the value that is specified in the Miscellaneous Section of the Security Group to which a User is defined.

The UPDATE Duration cannot be greater than the value that is specified in the Miscellaneous Section of the Security Group to which a User is defined.     

 

To end UPDATE mode press ATTN

The UPDATE command is not supported in the CICS and batch interfaces.

To find out more about this go to the SYSVIEW ISPF MENU, Primary Option Menu,

 

Then select…..

17 MENU HELP Online help information

 

Then select……

1 TOPICS Online knowledge base

 

Then go down to and select…….

HOWTO Auto update or refresh of screen displays  

 

Or you can issue the SYSVIEW command HELP UPDATE for Additional Information/Restrictions on the usage of the command.