I'm trying to run the ACFRPTSL report specifying REPORT(SHORT), DTCFIELD, and an extensive IF statement. I am getting an ACF49024 SYNTAX ERROR IN PARAMETER FIELD message and I can't figure out what the cause of the problem is.
search cancel

I'm trying to run the ACFRPTSL report specifying REPORT(SHORT), DTCFIELD, and an extensive IF statement. I am getting an ACF49024 SYNTAX ERROR IN PARAMETER FIELD message and I can't figure out what the cause of the problem is.

book

Article ID: 56571

calendar_today

Updated On:

Products

ACF2 ACF2 - DB2 Option ACF2 for zVM ACF2 - z/OS ACF2 - MISC PanApt PanAudit

Issue/Introduction

First change the DTCFIELD parm to specify DTCFIELD(YES) or DTCFIELD(NO). This is the proper syntax for this parameter. If that does not correct the problem, simplify the IF statement to one criterion and rerun the report. If the report runs successfully, then you will have to work on the original IF statement, eliminating criteria until you find the one causing the error. If the report still gets the same error message without the IF statement, then you should try removing other parameters one at a time. If you are still unable to determine the cause of the message, contact CA ACF2 for z/OS Technical Support.

Environment

Release:
Component: ACF2MS

Resolution

-

Powered by Wolken Software