New Options for Unicenter CA-JMR 4.6

Products

• JMR

Issue/Introduction

Does JMR 4.6 have any new options?

 

Environment

Release:
Component: JMR

Resolution

Prior to release 4.6, function changes for Unicenter CA-JMR was provided through the publication of special APARS. With the release of Unicenter CA-JMR Release 4.6, these function changes are now standard options that can be set during initialization.

The table below contains a list of the new options that were added to Unicenter CA-JMR Release 4.6, and the corresponding Special APARS they replace.

The following table shows the correspondence between the special APARs and the new options.

Unicenter CA-JMR Release 4.6
SPECIAL APAR	OPTION	PURPOSE
LS29557,A76801	ARCWAIT=Y/N	Wait for volume and/or unit when archiving
LS29556	SCNWAIT=Y/N	Wait for volume and/or unit when retrieving
LS43720	BATONLY=Y/N	Allows retrievals to run batch only
LS31170,A69180	JMR030A=Y/N	Automatic reply to JMR030A WTOR message
LS48009	SYSTEM	Specify offset for S Y S T E M in the JOB log
A73715	Standard	To show DATA ON TAPE message on TSO

The new parameters can be added to the option file that is allocated through the OPTIONS DD statement coded in the Unicenter CA-JMR 4.6 execution JCL.

For more information on the new options available in Unicenter CA-JMR Release 4.6, refer to the Unicenter CA-JMR User Guide.