How do I swap my production Teleview database with my Test database?
book
Article ID: 55637
calendar_today
Updated On:
Products
TeleviewTELEVIEW- PACKAGETPX - Session ManagementVman Session Management for z/OS
Issue/Introduction
Can the production Teleview database be swapped with the Test Database?
Resolution
There are two ways to swap your databases.
Select the OPER application in CA-Teleview. Select # 8, Halt or Start logons. Select # 11 issue SWAPDB Command. You will come to a screen that will show you your PROD and TEST database's. Hit ENTER to swap databases. While this is going on a halt logons will take place to prevent any new logons until the database is swapped. Then a Start logons will be preformed.
The second method of swapping databases is at the Operating Console you will issue the following command.
F STEPNAME, SWAPDB
Stepname = Where stepname is the system job name for the CA-Telview region.
Again a Halt logons and then a Start logons will occur while this is happening to prevent logons while swapping databases