When starting a system with a new level of z/OS, with the CA Disk OPEN SVC Zaps installed,
if during IPL several tasks abend and the Master Scheduler abends FF4-N/A and the IPL stops,
the FF4 abend is caused because the system can not find module ADSMVS60 during IPL.
Here is what to look for.
Console messages that can be seen are:
IKJ147I IKJEFXSR ABNORMAL TERMINATED IEE480I SET COMMAND ABEND FF4-N/A IEE480I SET COMMAND ABEND FF4-N/A IEFE001I ENF SYSPLEX-WIDE NOTIFIED IEA794I SVC DUMP HAS CAPTURED: DUMPID=001 REQUESTED BY JOB (SMF) ... DUMP TITLE=COMPON=SMF INITIALIZATION, ISSUER=IEEMB827, COMPID=SC100 *3190 IEA793A NO DUMP DATA SETS AVAILABLE FOR DUMPID=001 BY JOB (SMF ). USE THE DUMPDS COMMAND OR REPLY D TO DELETE THE DUMP IRA600I SRM CHANNEL DATA NOW AVAILABLE FOR ALL SRM FUNCTIONS *IEE479W MASTER SCHEDULER ABEND FF4, DUMPED, REIP - CODE 27 IEA794I SVC DUMP HAS CAPTURED: DUMPID=002 REQUESTED BY JOB (*MASTER*) DUMP TITLE=COMPON=MSTR-REGION,COMPID=SC1B8,ISSUER=IEEMB860,MAST ER SCHEDULER REGION INITIALIZATION DUMP *3191 IEA793A NO DUMP DATA SETS AVAILABLE FOR DUMPID=002 BY JOB (*MASTER*). USE THE DUMPDS COMMAND OR REPLY D TO DELETE THE DUMP
Make sure that:
1. The CA Disk OPEN SVC member ADSMVS60 is in the LPA library concatenation.
2. The SVC table has been updated by adding the following line to the IEASVCxx member of your SYS1.PARMLIB:
3. The number assigned to the OPEN SVC is the same as the value specified in each of the four SVC Zaps installed.
The default value in the zaps is x'F4' (d'244') and the instruction in the zaps is '0AF4'.
Most of the time the problem is the SVC number assigned.
The IEASVCxx entry is setup to use a different SVC number than SVC 244 (x'F4').
Changing the open zaps to the correct SVC number will solve the problem and permit the system to IPL successfully.