Librarian z/VSE: Error: V$001 NO ENTRY AVAILABLE IN SVA ANCHOR TABLE

Products

• Librarian

Issue/Introduction

Installing Librarian/CCF and running the job CCVUNLOD 

  See figure 4-9 in the Installation Guide - Install The Voice Procs (CA-VOLLOE Only)

Never had version control installed.

Output from ccvunlod.txt:

 V$001 NO ENTRY AVAILABLE IN SVA ANCHOR TABLE  
 OPEN OLL=OLLCNTL
 ==========================================================
USERID %%%
OLLFILE OPENED BEFORE SAFE PROCESSING INITIALIZED RUN CANCELLED.
ERROR CODE IS 0989. SEE SYSTEM REFERENCE MANUAL FOR FURTHER 
EXPLANATION.
===========================================================      
WRITE ERROR ON LIBRARY FILE.  RUN ABORTED..    
BACKUP FILE (SYS010) IS NOT ASSIGNED TO A VALID UNIT TYPE..      
INVALID BLKSIZE SPECIFIED..INSUFFICIENT GETVIS AREA..ERROR RELEA             
SING A GETVIS AREA..********** 1ST BLOCK OF OLLXXXX IS INVALID.
CANNOT CONTINUE.  CHECK DLBL/EXTENT CARDS FOR THE OLL..******** 
***** CANNOT ISSUE SUCCESSFUL ENQUE FOR THE ONLINE LIBRARY..OLL 
ENQUEUE LOGIC ERROR.  CALL ADR SUPPORT..FILE IS NOT EMPTY.  DELE 
TE AND REDEFINE THE FILE, THEN RERUN THE FORMAT PROGRAM..INTERNA 
L ERROR.  REFER TO MESSAGES AND CODES MANUAL FOR RECOVERY PROCED 
URES..ERROR RETURN FROM VSAM ON CALL FOR OLLXXXX..RETURN        
=========================================================== 
V$001 NO ENTRY            
             
AVAILABLE IN SVA ANCHOR TABLE.V$002 NO SVA MEMORY AVAILABLE.V$00             
3 PHASE ADRVFIL NOT FOUND IN CILV$004 ADRVFIL SUCCESSFULLY LOAD 
ED INTO THE SVA.V$005 ERROR FOUND AT OFFSET=.V$006 CHECKPOINT X, 
LOCK RETURN CODE=XX.V$007 ENQUEUE MISSING FOR MEMBER:.V$008 MCB       
CORRUPTION DETECTED FOR OLL=.V$009 INTERNAL ERROR XX-XX-XX-XXX             
TERMID=.V$010 READ I/O ERROR. BLOCK= OLL=.V$011 WRITE I/O     
ERROR.                
          
BLOCK= OLL=.V$012 UNSUPPORTED VERSION OF ADRVFIL FO1JOBNAME=CCVUNLOD  BG 
DATE=12/08/2008  TIME=13:29:14  CPUID=FF0D17BF 20868000  COMP=5686CF7068   
1C  PAGE  64

 

Environment

Librarian z/VSE 4.1 

Resolution

The program OLLX6100 is used for VOLLIE  V5.0

The program OLLE6100 is used for VOLLIE  V4.3

Change the program executed in the job according to the version of VOLLIE used and rerun the job.

In this situation, the customer is running VOLLIE 4.3 so the CCVUNLOD sample job needs to be changed to EXEC OLLE6100

Additional Information

CR24 RPJ

Q24 - requested SME review to determine if still valid