Running CAPM 2.8 and we are doing nightly backups using this command run as the dradmin user:
/opt/vertica/bin/vbr.py --task backup --config-file /home/dradmin/backup/backup_snapshot.ini
This has always worked, but since we did an upgrade to CAPM 3.0 the backups fail with this message:
[[email protected] backup]$ /opt/vertica/bin/vbr.py --task backup --config-file /home/dradmin/backup/backup_snapshot.ini
Error: Errors connecting to remote hosts: 10.86.248.220. Check SSH settings, and that the same Vertica version is installed on all nodes.
In CAPM 2.8 we used Vertica 7.1.2-6
This version of Vertica did not have a requirement for AllowTcpForwarding.
In CAPM 3.0 we used a newer version of Vertica, 7.2.3-2
In this version of Vertica (7.2.x), it is required that you set
CAPM 3.0 on LinuxVertica backups, this is applicable to remote backups and local backups using the vbr.py script.
Notice that by default it is commented out, that is because the default value is yes, if it has been edited of changed, change it back.
Match User dradmin
Note, if you edit this file, recycle sshd