NTP_RESPONSE response time issue

Products

• DX Unified Infrastructure Management (Nimsoft / UIM)

Issue/Introduction

NTP_RESPONSE probe response time limit

1. Open the ntp_response probe configuration and select Setup tab. Change the "Response time exceeds" value

<Please see attached file for image>

<Please see attached file for image>

Environment

UIM 8.31, 8.4, 8.42, 8.4.7

Cause

It is a defect as the required value is not updating in GUI or Raw Configure mode.

 

Resolution

Provided an new release version of ntp_response probe 1.42 with respective code changes.

Same probe can be downloaded from "http://support.nimsoft.com/Default.aspx?center=felles/archive"

<Please see attached file for image>

src="/servlet/servlet.FileDownload?file=0150c000004AKDfAAO" alt="ntp3.JPG" width="490" height="508">

Additional Information

Probe documentation:

https://docops.ca.com/ca-unified-infrastructure-management-probes/ga/en/alphabetical-probe-articles/ntp_response-network-time-protocol-response-monitoring/ntp_response-network-time-protocol-response-monitoring-release-notes