CA Jobtrac Job Management-AMR not working and the IEAVMXIT exit is active.

Products

• Jobtrac

Issue/Introduction

What should you do if the AMR table is not working while the IEAVMXIT exit is active?

 

Environment

Release:
Component: JOBTRC

Resolution

If someone enters in MVS, the 'K M' including parm 'UEXIT=Y' command, it refreshes the IEAVMXIT module in memory, There is a pointer in CA Jobtrac JM's GJTRVMXT module, which will result in AMR no longer functioning. This is the reason there is no abend and the 'D MPF' commands still show the module as active. Running

"S VINIT3,PARM='ONLY=GJTRVMXT"

will correct the problem. The AMR table will then start working. Additional information on recovering AMR to an active status can be found in the CA Jobtrac Reports and Maintenance Guide.