ALERT: Some images may not load properly within the Knowledge Base Article. If you see a broken image, please right-click and select 'Open image in a new tab'. We apologize for this inconvenience.
IKJ56644I NO VALID TSO USERID, DEFAULT USER ATTRIBUTES USED With TSS LIST Command In Batch
Article ID: 52648
Updated On:
Products
Top Secret
Issue/Introduction
When submitting a job that just does a "TSS LIST" on user ACIDs, the following message appears:
IKJ56644I NO VALID TSO USERID, DEFAULT USER ATTRIBUTES USED
There is a "USER=" parameter in the job control statements referring to a user ACID that is different from the submitter.
What does that message mean? How can it be stopped?
Environment
Release:
Component: AWAGNT
Component: AWAGNT
Resolution
When running TSS commands in batch, the program executing is IKJEFT01, which is a TSO program.
The message indicates the ACID could not be identified as a valid TSO user, so the default user attributes are used. CA Top Secret is not the one issuing the IKJ56644I message. It is TSO.
To stop the message:
- TSS ADD(acid) FACILITY(TSO) where 'acid' is the ACID the batch job is running under.
- And a TSO segment to the acid which the job is running.
Once the ACID has FACILITY (TSO) and a TSO segment, it is then a valid TSO user and the IKJ56644I message is not issued.
Feedback
Yes
No
Powered by
