ASM LPAR Agent Installation Credentials


Article ID: 52160


Updated On:


CA Unicenter NSM



The LPAR agent should use the hscroot account to access IBM's HMC (Hardware Management Console). Use the Dynamic Environment's Managed Node Configuration Utility to install and set up the calpara agent to monitor the LPAR frame.


To install the LPAR agent for a frame, using the hscroot account

Note: Using hscroot (or hscroot equivalent) is best practice because it ensures the necessary privileges are available. Contact CA Support for assistance if the hscroot user cannot be supplied.

To begin, select a Windows computer that has CA ASM installed and will run the LPAR agent.

To set up the LPAR agent

  1. Launch the Dynamic Environments Managed Node Configuration Utility.
    Note: This option is available after installing the ASM Managed Node, LPAR Performance Sponsor component.

    <Please see attached file for image>

    Figure 1

  2. Click Next on the Welcome wizard dialog.

    <Please see attached file for image>

    Figure 2

  3. Select Install Managed Node on the Select Installation Option dialog.

    <Please see attached file for image>

    Figure 3

  4. Click the Managed Node drop-down list and select IBM LPAR.

  5. Enter the HMC name= < HMC Host Name >, Username=hscroot and password=< password >.

    <Please see attached file for image>

    Figure 4

  6. Click Next to verify the authentication, then click Finish to add the LPAR agent.

  7. To verify the agent has been successfully installed, go to the command prompt and run awservices list.

  8. Verify from the output that the calpara:<lparframe> is running.

The LPAR agent is now set up, configured, and can be discovered and managed by CA NSM.


Component: UNINPO


1558713482728000052160_sktwi1f5rjvs16t3n.gif get_app
1558713480662000052160_sktwi1f5rjvs16t3m.gif get_app
1558713478832000052160_sktwi1f5rjvs16t3l.gif get_app
1558713474793000052160_sktwi1f5rjvs16t3k.gif get_app