ALERT: Some images may not load properly within the Knowledge Base Article. If you see a broken image, please right-click and select 'Open image in a new tab'. We apologize for this inconvenience.
After a failover to the Secondary Wireless LAN Controller (WLC), all the Access Points (APs) do not fallback to the Primary WLC
Article ID: 5210
Updated On:
Products
CA Spectrum
Issue/Introduction
The Access Points (APs) configured with the Wireless LAN Controller (WLC) active / passive information fails over to the Secondary WLC when the Primary WLC goes down, but all the APs will not fallback when the Primary WLC is up and running
Cause
The Primary and the Secondary WLC belong to different landscapes
Environment
Release:
Component:
Component:
Resolution
The Primary and the Secondary WLC should be discovered and configured under the same landscape for the failover and fallback to work properly
Additional Information
N/A
Feedback
Yes
No
Powered by
