How to create a SPECTRUM Threshold SpectroWatch with different thresholds on different models of the same type
Article ID: 52032
Updated On:
Products
CA Spectrum
Issue/Introduction
How to create a SPECTRUM Threshold SpectroWatch with different thresholds on different models of the same type
Environment
Release: Any
Component: SPCCSS - SpectroSERVER Core
Resolution
Use the Model Type Editor (MTE) to create custom read/write Integer attributes (one for the threshold value and one for the reset value) on the model type in question.
Then, on the individual models, populate the custom attributes with the threshold and reset values for that model. This can be done by:
1. Selecting the model
2. Click on the Attributes tab in the Component Detail panel
3. Filter for and select the attribute and set the values
When the SpectroWatch is created, specify these new attributes as the threshold and reset values for the Threshold SpectroWatch.
Then, on the individual models, populate the custom attributes with the threshold and reset values for that model. This can be done by:
1. Selecting the model
2. Click on the Attributes tab in the Component Detail panel
3. Filter for and select the attribute and set the values
When the SpectroWatch is created, specify these new attributes as the threshold and reset values for the Threshold SpectroWatch.
Additional Information
Please reference the "Watches" section of the documentation for more information.
Please reference the "Model Type Editor" section of the documentation for more information.
Please reference the "Model Type Editor" section of the documentation for more information.
Feedback
Yes
No
Powered by
