Clarity: Over-Allocation % does not work in Power Filter on the Resource Planning page

Products

• Clarity PPM SaaS
• Clarity PPM On Premise

Issue/Introduction

Description:

If you go to the Resource Planning page and create a power-filter using Over-allocation %, it does not return any results.

STEPS TO REPRODUCE:

1. Make sure you have at least one resource whose time is over-allocated by more than 10 % and a second resource whose time is not over-allocated.
   
   
2. Go to the Resource Planning : Workloads page.
   
   
3. Click on Expand Filter.
   
   
4. Click on [Build Power Filter] link.
   
   
5. Select the Over-allocation % field from the drop-down.
   
   
6. Choose >= for the Operator
   
   NOTE: It doesn't matter which operator you choose. None of them work.
   
   
7. Type 10 in the Constant field.
   
   
8. Click the Add button.
   
   
9. Click the Submit button.

EXPECTED RESULTS: Users who are over-allocated by >= 10% should be displayed.

ACTUAL RESULTS: No results are shown.

TECHNICAL DETAILS:

This happens under both Oracle and MSSQL. Tested under 12.0.1, 12.0.5 and 12.0.6 on vanilla systems.

Solution:

WORKAROUNDS:

Use the Over-allocation % field on the regular Filter page.

STATUS/RESOLUTION:

This issue has been documented as CLRT-51208 and is assigned to development for review. If you are experiencing this problem and the workaround above does not significantly help, please contact CA Clarity Technical Support.

KEYWORDS: CLARITYKB, resource, over-allocation, CLRT-51208, resource planning, filter, clarity12open, projmgr.workloads, projmgr.resourceWorkloads.

Environment

Release:
Component: STUDIO