Testrunner does not finish test suite

Products

• CA Application Test
• CA Continuous Application Insight (PathFinder)
• Service Virtualization

Issue/Introduction

We try to run a test suite in Test Runner and it ends prematurely as successful.  We do not know why it ends early as there is not an error message.

Cause

This is caused by the max errors set in the staging document.

Refer to section "Staging Document Editor" in the documentation of the DevTest release you are running.

 

• The Maximum number of errors before test is stopped field limits the number of errors that the test can have before LISA aborts it. A zero entry means to allow all errors.

Environment

All supported DevTest releases and platforms.

Resolution

Increase the max errors to the number required or set it to unlimited by setting it to 0

Additional Information

n/a