ALERT: Some images may not load properly within the Knowledge Base Article. If you see a broken image, please right-click and select 'Open image in a new tab'. We apologize for this inconvenience.

Clarity: When using a static dependent lookup in a filter, the selected values do not display after filtering

book

Article ID: 51637

calendar_today

Updated On:

Products

CA Identity Manager CA Identity Governance CA Identity Portal Clarity PPM SaaS Clarity PPM On Premise

Issue/Introduction

Description:

Details:

When using a static dependent lookup in a filter, the selected value(s) in the filter do not display after filtering. This behavior doesn't change whether the lookup style is single-select or multiple-select.

Steps to Recreate:

  1. Add the Stage attribute to the Project Filter layout.

  2. On the project list page, filter for a stage value.

Expected Result: Receive a list of projects based on the stage value selected in the filter, and for the value in the stage attribute in the filter to remain viewable.

Actual Result: Receive a list of projects based on the stage value selected in the filter, and for the value in the stage attribute in the filter does not remain viewable.

Solution:

Workaround:

None currently. Even though the value no longer shows in the stage filter, it is still being filtered on. Click on the trash can to clear the filter if needed.

Status\Resolution:

This issue has been documented as CLRT-54731 and is assigned to development for review.

Keywords: CLRT-54731, MVL, Filter, ClarityKB, Clarity12open.

Environment

Release:
Component: STUDIO
Powered by Wolken Software