After installing CA SymDump Batch or CA Optimizer/II r 8.5 and implementing the LE exit no dump is captured by either product when executing the demo program. Instead a U4039 abend is generated.
Article ID: 51454
Updated On:
Products
Issue/Introduction
Description:
Chapter six of the installation guide for CA SymDump Batch and CA Optimizer/II 8.5 outline the language environment (LE) installation considerations. After the LE configuration for either product has been completed you execute the DEMO program shipped to verify the installation. When executing the DEMO program which produces an abend by design neither product captures the abend and LE generates a user U4039 abend.
Solution:
After the LE configuration for either product has been completed you execute the DEMO program shipped to verify the installation you receive a U4039 abend (Below) and no dump is captured by CA SymDump Batch and CA Optimizer/II.
IEA995I SYMPTOM DUMP OUTPUT 676
USER COMPLETION CODE=4039 REASON CODE=00000000
TIME=12.59.49 SEQ=00539 CPU=0000 ASID=003A
PSW AT TIME OF ERROR 078D1000 868D79FE ILC 2 INTC 0D
NO ACTIVE MODULE FOUND
NAME=UNKNOWN
DATA AT PSW 068D79F8 - 00181610 0A0D58D0 D00498EC
AR/GR 0: 8EB7AEDE/84000000 1: 00000000/84000FC7
2: 00000000/0008BA78 3: 00000000/00060007
4: 00000000/068CC0D8 5: 00000000/0008B5DC
6: 00000000/00000000 7: 00000000/0F35E2A8
8: 00000000/0008BA78 9: 00000000/0008D156
A: 00000000/0008B5DC B: 00000000/068D7928
C: 00000000/00077B58 D: 00000000/0008E278
E: 00000000/868CB1BC F: 00000002/00000000
END OF SYMPTOM DUMP
This is known problem caused by LE option TERMTHDACT(UADUMP).
The CA SymDump Batch and CA Optimizer/II installation guide states that no dump will be captured if your LE configuration uses TERMTHDACT(UADUMP).
Note: The LE option TERMTHDACT(UADUMP) generates a U4039 abend when an unhandled condition occurs of severity 2 or greater.
CA SymDump Batch or CA Optimizer/II will not report on this abend.
As a test you may what to set TERMTHDACT(TRACE,,96).
Environment
Component:
Feedback
