CADT027W DYNAM/T TAPE nnnnnn NOT IN CATALOG

Article Id: 51442
Status: Published
Updated On: 14-02-2018 07:01
Legacy Id: TEC528733
Products:
CA Dynam for VSE , CA Dynam VSE Option
Issue/Introduction:

Description:

After a new VOLSER Range has been added to the Catalog (CAICATL) and to the IBM Robot Library we receive Message:

CADT027W DYNAM/T TAPE nnnnnn NOT IN CATALOG for any of this VOLSER Numbers.
What is the Cause and how can we Correct it?

Solution:

Message CADT027W DYNAM/T TAPE nnnnnn NOT IN CATALOG can have several Reasons:

  1. VOLSER Range was added to the Catalog (CAICATL) and Robot Library without Initialization...
    They need to be Initialized by Program DYNCAT with Command INT

  2. If System Option 'Check Catalog Ownerid during AVR' is set to: YES (OWNCHK=YES in the DTPARMS ASSEMBLE file) and the field in the tape HDR record does not contain a Ownerid.
    Reinitialize the tape with Program DYNCAT and Command INT or change System Option 'Check Catalog Ownerid during AVR' to: NO (OWNCHK=NO in the DTPARMS ASSEMBLE file)

Environment:

Release:
Component: DYNTVM