CAHC431I Check detected non-applicable environment RC=08
search cancel

CAHC431I Check detected non-applicable environment RC=08

book

Article ID: 50233

calendar_today

Updated On:

Products

COMMON SERVICES FOR Z/OS SYSVIEW Performance Management NXBRIDGE - SYSVIEW/ENDEVOR

Issue/Introduction

When starting SYSVIEW and you have not enabled the use of IBMs Health check, you may get this message.

 

 

 

Environment

SYSVIEW

Cause

This message is informational only. CA product health check routine determined that the execution environment is not applicable to the conditions for which the check is designed to examine.

Resolution

IBM Health Check is activated by default in CA Sysview. If your installation does not use IBM Health Check, you will get:

CAHC431I Check detected non-applicable environment RC=08

You may deactivate the check routine by putting:

ASADMIN then CL then "P" to stop the HCHECK subtask

To NOT start HCHECK in the SYSVUSER STC put NOSTART HCHECK into the parmlib member. Otherwise you just may ignore the message.