Errors when running SSdbsave from the command line

Products

• CA Spectrum
• DX NetOps

Issue/Introduction

Errors when running SSdbsave from the command line

Example:

[spectrum@spectrum SS-Tools]$ ./SSdbsave -mv test
**************************************************************************
The following output is intended to facilitate debugging, please forward
to CA technical support.  The files listed are not part of the customer
installation of SPECTRUM.
**************************************************************************

Jan 14 13:45:39 ERROR TRACE at CsSSDbRp.cc(658): table open failed  @  TableImpl.cc:661
      (0x2)  Db::open: No such file or directory

 SPC-DBS-20095: ./SSdbsave Error:  Unable to open database.

Environment

Release: All Supported Releases
Component: SPCCSS - SpectroSERVER Core

Cause

SSdbload not run from the $SPECROOT/SS directory

Resolution

The SSdbsave utility must always be run from the $SPECROOT/SS directory 

Here is an example of usage from the $SPECROTT/SS directory:

../SS-Tools/SSdbsave -cm db_example

Additional Information

Please reference the "SSdbsave" section of the documentation for more information.