After installing CA ACF2 r15, attempts to APPLY aggregate maintenance fail with message GIM65802E. What is wrong or missing?

book

Article ID: 49113

calendar_today

Updated On:

Products

CA ACF2 CA ACF2 - DB2 Option CA ACF2 for zVM CA ACF2 - z/OS CA ACF2 - MISC CA PanApt CA PanAudit

Issue/Introduction

Description:

Message GIM65802E states:

GIM65802E MODULE modname IS NEEDED TO BUILD THE FOLLOWING LOAD MODULES

FOR SYSMOD sysmod1 BUT IS NOT FOUND. THE MODULE IS NOT IN
DISTRIBUTION ZONE zonename, AND SYSMOD sysmod2 WHICH LAST
REPLACED THE MODULE IS NOT IN THE SMPPTS.

This means that SMP/E could not find the modules needed to build the specified load module. During load module build processing, SMP/E searches the distribution zone for the needed modules and the SMPPTS for any indicated RMID (replacement) modules.

The initial install of CA ACF2 r15 is not complete until the ACCEPT is performed to populate the distribution zone and libraries.

Solution:

Ensure that the ACCEPT of the CA ACF2 r15 FMIDs completed successfully. If not accepted run the ACCEPT, sample job/member ACF5ACC in the CA ACF2 provided SAMPJCL library.

The ACCEPT processing populates the distribution zone and distribution libraries.

Environment

Release:
Component: ACF2MS