After initial install of ACF2, aggregate maintenance APPLY fails with GIM65802E.

Products

• ACF2
• ACF2 - DB2 Option
• ACF2 for zVM
• ACF2 - z/OS
• ACF2 - MISC

Issue/Introduction

The RECEIVE and APPLY of the ACF2 product has been successful. Now when applying aggregate maintenance, the APPLY fails with one or more of this message:

GIM65802E ** MODULE ACFF6UPG IS NEEDED TO BUILD THE FOLLOWING LOAD MODULES FOR SYSMOD RO89274 BUT IS NOT FOUND. THE     
              MODULE IS NOT IN DISTRIBUTION ZONE CAIDL1, AND SYSMOD RO80309 WHICH LAST REPLACED THE MODULE IS NOT IN THE 
              SMPPTS.

 

 

 

Environment

Release:
Component: ACF2MS

Cause

SMP/E could not find the modules needed to build the specified load module. During load module build processing, SMP/E searches the distribution zone for the needed modules and the SMPPTS for any indicated RMID (replacement) modules.

Resolution

The initial install of ACF2 is not complete until the ACCEPT is performed to populate the distribution zone and libraries.

The ACCEPT of the ACF2 FMIDs must be completed successfully. ACCEPT processing populates the distribution zone and distribution libraries.