Auto monitors are not showing in vmware probe, on expanding a V-center

Article Id: 4742

Status: Published

Updated On: 14-02-2018 07:54

Legacy Id: TEC1449669

Products:

CA Unified Infrastructure Management On-Premise (Nimsoft / UIM) , NIMSOFT PROBES

Issue/Introduction:

Auto monitors are not showing in vmware probe, on expanding a V-center.

Cause:

In the vmware.cfg, when auto monitors and static monitors are mixed / duplicated for specific resource. This issue generally happens.

Environment:

UIM Version: 8.xVmware probe

Resolution:

Following below steps should resolve the issue:

1. deactivate vmware probe
2. Take vmware.cfg backup
3. Remove the below part from vmware.cfg

<monitors>
XXXXXXXXX
</monitors>