How to reset Change status for APPLYING psp

Products

• MICS Resource Management

Issue/Introduction

I am in the process of applying MICS maintenance and when I go to select the changes, I see that some PTFs are in APPLYING status. 
I checked the source members and it looks like they were applied.
In addition, I ran sp.CNTL(PSPSTAT) which shows that the PTFs were successfully applied in the past.    
How can I reset the status in MWF?

 

 

Environment

Release: 14
 

Resolution

Run the job located in sp.PSP.CNTL(MAAUDIT) for each fix which will mark them as complete.

Additional Information

Refer to the section in the MICS doc on 'Completing the Product Change Apply Job Successfully'