Receiving "No mount authority" Message
Article ID: 46165
Updated On:
Products
Deliver
View
Issue/Introduction
When doing an "S" for a report select, on a View Sysout Selection panel, for a report that is only on tape, the client received message "No mount authority".
Environment
CA View - All Releases
Resolution
The client had SARINIT parameter "TAPEOPT=3480,...", which means that archival tapes are written using 3480 (includes 3490 and 3590) data block location processing.
When doing retrieval of a report from tape with that setting, you need first to do a SARBCH /LOAD of the report to the disk layer.
Client changed the parameter to "TAPEOPT=EAST,..." and (as they are licensed for EAS) were able to access and browse the report as expected.
When doing retrieval of a report from tape with that setting, you need first to do a SARBCH /LOAD of the report to the disk layer.
Client changed the parameter to "TAPEOPT=EAST,..." and (as they are licensed for EAS) were able to access and browse the report as expected.
Feedback
Yes
No
Powered by
