After upgrading OPS/MVS receiving error message OPS0049E even though OPJ2CB module no longer requires assembly

Products

• OPS/MVS Event Management & Automation

Issue/Introduction

After having upgraded OPS/MVS the below error message OPS0049E is being shown although the documentation states  OPJ2CB module no longer requires an assembly for supported releases of z/OS.   

OPS0049E INCOMPATIBLE VERSION OF JES2 OFFSET TABLE FOUND, REASSEMBLE OPJ2CB

OPS3257I Module name (OPJ2CB) reloaded at X'1A7CB008'

 

Environment

OPS/MVS, all releases starting with release 12.3 and above

Cause

One possible cause is that there is a JES2OFFSETSUFFIX parameter set in the OPS/MVS initialization program telling OPS/MVS to look for a module named OPJ2CBxx.

Resolution

Use one of the solutions below:

1. Remove the JES2OFFSETSUFFIX parameter from the initialization program (usually OPSSPA00) and recycle OPS to let it use the default OPJ2CB module.
2. Use the member JES2ASM from the library CCLXCNTL to recreate the JES2 interface module (OPJ2CBxx) with the suffix indicated by the parameter JES2OFFSETSUFFIX.